04-29-2015 03:29 PM
I am trying to configure the cimc ip of a UCSE-160d blade but when I telnet to the ISR 4451 router and try this
config t
enable
interface ucse 1/0/0
imc
does not recognize imc command.
http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/2-0/gs/guide/b_2_0_Getting_Started_Guide/b_2_0_Getting_Started_Guide_chapter_0101.html
also I only have one double wide blade on this chassis but I see ucse has 1/0/1 as well
what is that?
12-22-2015 12:52 PM
You figure this out?
09-05-2017 08:35 AM
hi,
Ive got a e160-d card within my 2921 isr and what i did was the following
-----------
int ucse1/0
ip unnumbered BVI1
imc ip address xx.xx.xx.xx xxx.xxx.xxx.xxx default-gateway xx.xx.xx.xx
imc access-port dedicated
bridge-group 1
------------
and everything went fine with me :)
im running latest firmware etc via HUU 3.1.4 and updated BIOS as well
hope this helps
Mike
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: