Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

tim
New Member

Citrix Bandwidth calculation per host

Does any one have a rule of thumb for Citrix Bandwidth calculation per host for planning issues.

Thanks

4 REPLIES

Re: Citrix Bandwidth calculation per host

hi

thoeritically it requires 16Kbps per host ...

regds

prem

tim
New Member

Re: Citrix Bandwidth calculation per host

Thanks for the info do you have a doco that supports this.

New Member

Re: Citrix Bandwidth calculation per host

Hi there tim,

We used the following :

#workstations * 1,3 * 20 = the amount of bandwith needed for out remote location

But the 1,3 is a 100% concurency and an inefficiency of 30% of the WAN.

this is a quite high !!! so you have to find out how "good/efficient" your network is and the concurrency factor on your remote locations.

We also found out that an powerfuse shell (www.powerfuse.com) adds another 10 Kbit to your session bandwith instead of the normal explorer shell.

so you also have to look at which shell you are going to use and the effect it has on the bandwith needed.

New Member

Re: Citrix Bandwidth calculation per host

1236
Views
3
Helpful
4
Replies