Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

command to see transmit qeueing drops in Nexus 5548

Hello, 10g links in our core are getting rather congested as seen by MRTG graphs. Any command on Nexus 5548 to show transmit queuing drops on a given interface?

1 REPLY
New Member

command to see transmit qeueing drops in Nexus 5548

You could use #show queing interface eth 1/1

it shows you output similar as below:

NEXUS-1# show queuing interface ethernet 1/1

Ethernet1/1 queuing information:

  TX Queuing

    qos-group  sched-type  oper-bandwidth

        0       WRR            100

  RX Queuing

    qos-group 0

    q-size: 470080, HW MTU: 9216 (9216 configured)

    drop-type: drop, xon: 0, xoff: 470080

    Statistics:

        Pkts received over the port             : 222434

        Ucast pkts sent to the cross-bar        : 199674

        Mcast pkts sent to the cross-bar        : 22760

        Ucast pkts received from the cross-bar  : 101087

        Pkts sent to the port                   : 145083

        Pkts discarded on ingress               : 0

        Per-priority-pause status               : Rx (Active), Tx (Inactive)

  Total Multicast crossbar statistics:

    Mcast pkts received from the cross-bar      : 43996

350
Views
0
Helpful
1
Replies
CreatePlease to create content