Configuring failover on Local Director

[loyalty]

I have two Cisco Local Director platforms (416) and I'm trying to configure stateful failover on them. I think I have done everything right but when I enter Show Failover command on the Primary (active) Unit is shows the secondary (standby) Unit is 'Normal (Waiting)', while the primary is 'Normal'. Would apreciate any suggestions thanks.

[thisisshanky]

http://www.cisco.com/en/US/products/hw/contnetw/ps1894/products_installation_guide_chapter09186a008007d466.html#xtocid28795

Hope this explanation helps!