I have two Cisco Local Director platforms (416) and I'm trying to configure stateful failover on them. I think I have done everything right but when I enter Show Failover command on the Primary (active) Unit is shows the secondary (standby) Unit is 'Normal (Waiting)', while the primary is 'Normal'. Would apreciate any suggestions thanks.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...