On this page these are the config lines they instruct to use:
switch(config)# logging server 172.28.254.254 5 local3
With "5" being the severity level and "local3" being the outgoing facility.
If level 5 is chosen, does that log levels 0 through 5? Levels 6 and 7 are described as "information message ONLY" and "appears during debugging ONLY" - so if 6 is chosen, does that mean 0 through 6? or just 6?
Also, I'm not sure I understand the facility part... any help there would be appreciated.
A lower number in severity indicates higher severity so if you choose 6 that monitors 0-6 severity levels of facility specified. Facility can be specified using "logging level " command. You can see defaul facility levels using show logging level command
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...