Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CSNA and DLSw+ Config on CIP Router

Is it possible to configure both CSNA and DLSw+ on the same router, which is CIP attached to the mainframe?

For example;

User (SNA) -- Customer Router (DLSw+ Peer) -- ISDN -- Central Router (DLSw+ Peer) -- CIP -- Mainframe

Central Router#

!

dlsw local-peer peer-id … cost 1 lf 1500

dlsw icanreach mac-address 4000.7507.a0a1 mask ffff.ffff.ffff

!

interface Channel1/0

csna …

!

interface Channel1/2

lan TokenRing 1

adapter 1 4000.7507.a0a1

!

Will users at customer sites be able to use the 4000.7507.a0a1 destination MAC address for connecting to the mainframe using SNA?

Thanks in advance for your help.

1 REPLY
Silver

Re: CSNA and DLSw+ Config on CIP Router

Yes, it is.

As the configuration attached is not complete, I am not sure if this is a configuration issue. You need the folloowing commands:

1. global command source-bridge ring-group Z, where Z is a number ranges from 1-4095 and is unique in the SRB infrastructure.

2. under Lan TokenRing 1, you need source-bridge X Y Z. Z is the number you define in source-bridge ring-group.

For examples, please go to the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ibm_c/bcprt2/bcdcmpc.htm#85455

214
Views
0
Helpful
1
Replies