Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CSS load balancing and Remote desktop

hi all!

here is config:

!*************************** GLOBAL ***************************

cdp run

ip redundancy

ip route 0.0.0.0 0.0.0.0 10.12.248.1 1

!************************* INTERFACE *************************

interface 2/1

bridge vlan 2

interface 2/2

bridge vlan 3

!************************** CIRCUIT

circuit VLAN1

redundancy

ip address 10.12.248.101 255.255.248.0

circuit VLAN2

ip address 192.168.1.1 255.255.255.252

redundancy-protocol

circuit VLAN3

redundancy

ip address 192.168.7.25 255.255.255.0

!************************** SERVICE **************************

service Node1

ip address 192.168.7.23

active

service Node2

ip address 192.168.7.24

active

!*************************** OWNER ***************************

owner RenCap

content Cluster_Nodes

add service Node1

add service Node2

vip address 10.12.248.100

active

content Mngmnt_Node1

add service Node1

vip address 10.12.248.102

active

content Mngmnt_Node2

add service Node2

vip address 10.12.248.103

active

CSS_Primary#

Remote desktop of Node1 and Node2 is accesible, but only by local login and password.

How i can use tacacs for authentication on Node?

in other words, how can be LAN servers available from Node1 and Node2?

1 REPLY
Anonymous
N/A

Re: CSS load balancing and Remote desktop

The document http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a0080094848.shtml gives a complete configuration exmaple on Configuring TACACS Authentication with VPN Client.

349
Views
0
Helpful
1
Replies
CreatePlease login to create content