Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

CSS trouble (disk full without useful file)

Hi all,

i've got problem with CSS 11150 SW Version: 5.00 Build 63, so i can try to upgrade OS of CSS but after 3 timeout in uploading the disk was full with a part of the OS (i've tried 3 times...). SO now i have not idea about how can i clean the disk...i'm sure i've got a lots useless file but i don't know how see and erase them. How you can see (see below) just one uncompressed OS is present on the system....may you help me?

THK a lot

cssA# show disk

Disk Size: 216 MB

Disk Free: 2 MB

Bad Cluster Count: 0

File Count: 648

Directory Count: 103

cssA# show installed-software

ap0500063

2 REPLIES
Silver

Re: CSS trouble (disk full without useful file)

I think as you know that, by default, the CSS saves boot and subsystem event log messages to log files on the hard or Flash disk. The content of these files is recorded in ASCII text. You can also configure the CSS to send log messages to an active CSS session, email address, or another host system. The maximum size of a local log file is 50 MB for hard disk-based systems and 10 MB for Flash disk-based systems.

Silver

Re: CSS trouble (disk full without useful file)

On some systems, after deleting a file, you have to use a form of "shrink" command to enable device to use available space. I don't know if that's the case with CSS though.

140
Views
4
Helpful
2
Replies
CreatePlease to create content