Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

custom-queue-list on FR subinterface

Do custom-queue-list definitions apply to Frame-Relay subinterfaces. I liked to configure something like that:

<p>

interface Serial1/0.4 point-to-point

<p>ip address 10.1.1.5 255.255.255.0

<p>frame-relay class test

<p>frame-relay interface-dlci 54

<p>map-class frame-relay test

<p>no frame-relay adaptive-shaping

<p>frame-relay custom-queue-list 1

<p>queue-list 1 protocol ip 1 list 100

<p>queue-list 2 protocol ip 2 list 101

<p>queue-list 1 default 3

<p>queue-list 1 queue 1 byte-count 2048

<p>queue-list 1 queue 2 byte-count 1024

<p>queue-list 1 queue 3 byte-count 512

<p>

We have more than one subinterface on a frame-relay link. On one we like to do traffic management on the others not.

1 REPLY
Anonymous
N/A

Re: custom-queue-list on FR subinterface

You're on the right track. Just apply the map-class created to the sub-interface

dlci you're intrested in.

the other sub interface would not be affected unless you use the same map-class for them.

if they also need to have parameters added to them via a map

class, then creat and entirely different one for the other.

Each dlci inherits only the map-class attached to it, or

if none is attched inherits the map-class attached to the physical

interface.

309
Views
0
Helpful
1
Replies
CreatePlease login to create content