using VTP implies to have vlan id < 1005. I guess there are some big datacenter which need more than 1000 vlans, or for numbering logic, adminsitrator want to use vlan id > 1005. Do you use VTP in your case, or do you disable it (and, for example, making vlans provisioning in order to have to create all the future vlans, and using generic vlan names)?
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...