We want to backup a serial line, connected to a 7200, which, by itself, is connected to a radius-server. Via Ethernet, we have an as5300 connected to the 7200, where the ISDN backup should terminate. The problem is, that if the 7200 goes down, the effect is that
<p>a) backup ddr is triggered
<p>b) no connectivity to radius is available.
<p>So the CPE dials, and dials, and dials (about 15 times a minute, with no success of course).
any idea for this scenario? how can i configure a backoff, which dials for example 3 times, waits for 2 minutes, dials 3 times, waits for 4 minutes ... and so on?
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...