I have attached a quick Visio I put together to illustrate what I have setup already. I am trying to make this a redundant setup so that if any of the links fails for a vlan on the side of the active asa that the other asa will take over as the active for that VLAN. I am not entirely sure that this is possible but I am open to any possible workarounds except for making the asa's active/active. Any redesign suggestions are welcome as well, but I have to keep the ASA's...no FWSM. Any ideas how I can make this as redundant as possible would be much appreciated!
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...