Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Eth. T/R DLSw w/ Redundancy

I have an ethernet segment and a Token Ring segment.

I have 2 routers connecting to both the Ethernet and the Token Ring. Both routers have a serial interface. I'm attempting to have dlsw redundancy for both Ethernet and Token Ring.

I noticed that when I 'Ping' from Ethernet to T/R, I get duplicate responses. I've been forced to disable redundancy for DLSw on the Token Ring. Is there any reason this might happen?

Any help will be greatly appreciated.

  • Server Networking
1 REPLY
New Member

Re: Eth. T/R DLSw w/ Redundancy

You may have a routing or bridging loop. It's difficult to troubleshoot on this type of message board. I'd suggest you open a case with the TAC and request some design help and configuration review. That way you can describe your specific situation and include diagrams of your network.

146
Views
0
Helpful
1
Replies