Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How can I configure two rp-addresses?

I am running IP PIM Sparce-Mode on all of my routers. I have a hub and spoke frame relay voice network. The hub is my rp for all of the spokes. One of the spokes will need to terminate two other spokes off of it. My question is how do I configure this router to have two rp, one of for one of it voice group and the other for the other voice group that will terminate into it?

1 REPLY
Anonymous
N/A

Re: How can I configure two rp-addresses?

You will need to use ACLs for

each multicast group, with the

"ip pim rp-address "

command.

You can find an example plus config

at this URL :

http://www.cisco.com/warp/customer/105/48.html#A3

194
Views
0
Helpful
1
Replies