01-15-2012 08:52 PM
Hi,
I am able to configure jumbo frames on nexus 5000 at switch level, however i want to do the same at interface level, is there any way that can be done ? is it supported ?. i dont want all my ports to be configured with jumbo frames in one shot.
Regards,
Manju
Solved! Go to Solution.
01-16-2012 03:52 PM
If it is L2 only, system level config will take care of it.
The only time you need to configure it on the interface level is when you have L3 interfaces.
Regards,
jerry
01-16-2012 03:52 PM
If it is L2 only, system level config will take care of it.
The only time you need to configure it on the interface level is when you have L3 interfaces.
Regards,
jerry
01-16-2012 11:30 PM
Thanks Jerry, i got your point. As i was seeing this possible in brocade 8000 switch, wanted to know if possible in nexus 5000 as well.
Regards,
Manju
01-17-2012 12:22 AM
Jerry,
Does this mean its not possible to set at interface level in nexus ?
Regards,
Manju
01-17-2012 02:27 AM
For L2, you don't need to set it at interface level (it will not do anything), set it at system qos will take care the job.
Regards,
jerry
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: