Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How configure jumbo frames on nexus 5000 at interface level

Hi,

I am able to configure jumbo frames on nexus 5000 at switch level, however i want to do the same at interface level, is there any way that can be done ? is it supported ?. i dont want all my ports to be configured with jumbo frames in one shot.

Regards,

Manju

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

How configure jumbo frames on nexus 5000 at interface level

If it is L2 only, system level config will take care of it.

The only time you need to configure it on the interface level is when you have L3 interfaces.

Regards,

jerry

4 REPLIES
Cisco Employee

How configure jumbo frames on nexus 5000 at interface level

If it is L2 only, system level config will take care of it.

The only time you need to configure it on the interface level is when you have L3 interfaces.

Regards,

jerry

New Member

How configure jumbo frames on nexus 5000 at interface level

Thanks Jerry, i got your point. As i was seeing this possible in brocade 8000 switch, wanted to know if possible in nexus 5000 as well.

Regards,

Manju

New Member

Re: How configure jumbo frames on nexus 5000 at interface level

Jerry,

Does this mean its not possible to set at interface level in nexus ?

Regards,

Manju

Cisco Employee

Re: How configure jumbo frames on nexus 5000 at interface level

For L2, you don't need to set it at interface level (it will not do anything), set it at system qos will take care the job.

Regards,

jerry

1156
Views
0
Helpful
4
Replies
CreatePlease login to create content