Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How do I remove the Serial Interface and Controller T1 entries from the configuration when using a PA-MC-4T1

I cant seem to remove the int se1/2:2 from the config. I have a PA-MC-4T1 card configured for T1 service. Below is what is left in the config.

controller T1 1/2

framing esf

linecode b8zs

channel-group 2 timeslots 1-24

!

controller T1 1/3

framing esf

linecode b8zs

channel-group 3 timeslots 1-24

!

interface Serial1/2:2

bandwidth 1536

no ip address

no ip redirects

no ip unreachables

encapsulation frame-relay IETF

shutdown

no fair-queue

!

interface Serial1/3:3

bandwidth 1536

no ip address

no ip redirects

no ip unreachables

encapsulation frame-relay IETF

frame-relay lmi-type ansi

1 REPLY
Anonymous
N/A

Re: How do I remove the Serial Interface and Controller T1 entri

As long as you have the command

"channel-group 2 timeslots 1-24"

under the controller T1 1/2, that

serial interface will exist. You

can't manually delete it, you would

need to remove/change the channel-

group command.

271
Views
0
Helpful
1
Replies