We have HP C7000/VC-Flex 10 Module that I would like to connect to our Netapps NFS datastore. The Cisco switch that I will be using between HP Flex-10 and Netapps is Cisco 4900M. I have a HP cable AP784A direct attach copper SFP+ to SFP+. Which module I need to purchase and insert into my 4900M to support 10Gb connectivity via HP DAC 10Gb cable.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...