Is it possible to create a shared uplink set between 2 HP VC FlexFabric 10Gb/24-Port Module connecting to 2 Cisco 4500-Xs in VSS (total of 4 links)? Traditionally I've been created 1 SUS for each VC going into Cisco Nexus 5Ks. Each SUS is active/active and then within VMware each vSwitch has both SUS links. This works well, but I'd like to know if there's a better way to be doing things.
AFAIK it is not possible to set up LACP across the VC bays. The VSS side supports multichassis LACP but VIrtualConnect side does not. (But the screenshot shows Active-Standby which does not seem to be LACP.)
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...