We are looking to implement Windows Hyper V 2012 in our data center, and apparently, this comes with some potential virtual switching options.
Does the Hyper-V Extensible Switch allow VMs within the hypervisor to connect to a virutal switch using "virtual network adapters"? In other words, can I create 20 VMs in the hypervisor, give them virtual adapters and IP addresses, create vlans on the virtual switch, and then trunk physical adapters on the system to an upstream Cisco switch? Is this possible?
I've been having a hard time finding information on exactly how this Hyper-V Extensible Switch works.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...