Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

I have a question about GSS

I must install two gss on active/standby mode

First, I enable one GSS to primary gssm, like below

#gss enable gssm-primary

and then I enable the other gss to secondary gssm like below

#gss enable gssm-standby (gssm-primary'ip)

In the configuration, Is it a correct?

and How can I cabling each other?

Must it be in same sagment to establish active/standby mode?

Or, don't care when gss can communication

each other?

in the dns server, How can I setup ip address?

dns must look at two ip(active gss, standby gss)? or only active gss?

thank for your reply.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: I have a question about GSS

Hi syejeon,

GSS's can be in different networks and there should be communication between the GSS's.

In the interface configuration - you need to define "gss-communications".

Check the link for the GSS-DNS configuration

http://www.cisco.com/en/US/products/hw/contnetw/ps4162/products_configuration_guide_chapter09186a00807e0a20.html#wp1064279.

1 REPLY
New Member

Re: I have a question about GSS

Hi syejeon,

GSS's can be in different networks and there should be communication between the GSS's.

In the interface configuration - you need to define "gss-communications".

Check the link for the GSS-DNS configuration

http://www.cisco.com/en/US/products/hw/contnetw/ps4162/products_configuration_guide_chapter09186a00807e0a20.html#wp1064279.

251
Views
0
Helpful
1
Replies
CreatePlease to create content