Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

IGESM in IBM blade center

Hi all,

Is anybody knows how to get telnet access to IGESM in IBM blade servers?

basically i need to enable trunking between this module and uplink switch.

Thanx in advance.

Regards,

Rajesh

4 REPLIES
Community Member

Re: IGESM in IBM blade center

Hello,

You need to enable the external management from the management module.

Here you'll find the user guide for IGESM switch :

http://www.redbooks.ibm.com/redpapers/pdfs/redp3869.pdf

Pages 55 and 248 might interest you!

Please rate if this helps.

Regards,

Christophe

Silver

Re: IGESM in IBM blade center

The three OEM blade server switches for HP,IBM, and now Dell are a joy to work with...not.

With the IBM series please be sure that you notate what version of code is running on it and keep track of it because its the minimum version it supports. You put a earlier version on it, reboot, and you'll get a nice four port brick.

Community Member

Re: IGESM in IBM blade center

Hi,

I think, if you know the ip address of the management module and if access is there you can access.

Else connect a console cable to the management console port and access the same.

You need to understand the bladecenter cisco n/w architectuer before you you try your hand.

good luck.

Community Member

Re: IGESM in IBM blade center

Here is a good Cisco IBM Blade Design Guide for your reference.

247
Views
5
Helpful
4
Replies
CreatePlease to create content