04-04-2006 04:58 AM
Hi all,
Is anybody knows how to get telnet access to IGESM in IBM blade servers?
basically i need to enable trunking between this module and uplink switch.
Thanx in advance.
Regards,
Rajesh
04-08-2006 04:07 AM
Hello,
You need to enable the external management from the management module.
Here you'll find the user guide for IGESM switch :
http://www.redbooks.ibm.com/redpapers/pdfs/redp3869.pdf
Pages 55 and 248 might interest you!
Please rate if this helps.
Regards,
Christophe
04-13-2006 04:09 AM
The three OEM blade server switches for HP,IBM, and now Dell are a joy to work with...not.
With the IBM series please be sure that you notate what version of code is running on it and keep track of it because its the minimum version it supports. You put a earlier version on it, reboot, and you'll get a nice four port brick.
08-13-2006 08:18 PM
Hi,
I think, if you know the ip address of the management module and if access is there you can access.
Else connect a console cable to the management console port and access the same.
You need to understand the bladecenter cisco n/w architectuer before you you try your hand.
good luck.
08-15-2006 07:01 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: