I have 2 7206's with CPA cards Escon attached to an IBM host. I'm trying to get IP failover to work without using EMIF. If I fail one of the boxes, IP rolls over to the second box. When I power that box back up, IP stops working. If I then do a shutdown on the channel (on the box that was initially powered off), IP again works. On the host, they have 2 defaultnet statements, 1 pointing to each CPA port. Any ideas/thoughts would be appreciated.
You should be able to use one IP stack on the mainframe, configured to connect simultaneouslly to the two CPA cards with the appropriate DEVICE and LINK statements, but use the VIPA address option so that the end users are not tied to a particular CPA interface.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...