Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IP source based Load balancing?

Hi all;

We encounter the following issue:

A load balancer directs requests in a round robin mechanism to several servers. We want the load balancer direct requests based on the source IP addresses, so that the same host would be directed to the same server at each time it reaquests to be connected (reconnection). Is this possible when using CSM module knowing that NAT is implemented?

Regards

2 REPLIES
New Member

Re: IP source based Load balancing?

Yes this is possible doing

vserver VAPP

virtual 10.1.1.11 tcp 2514

serverfarm SAPP

sticky 90 group 8

idle 5400

persistent rebalance

inservice

sticky 8 netmask 255.255.255.255 address source timeout 90

This should make the session sticky

New Member

Re: IP source based Load balancing?

Very helpful. Thank you.

143
Views
6
Helpful
2
Replies
CreatePlease to create content