Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ipx over frame relay and route redistribution

Hi,

When I configure ipx over frame-relay multipoint interface, I need to run eigrp and disable the split horizon, and I'm running ipx rip on the same router thus, redistribution is automatic by default. This will cause potential routing loop when the route is advertised back from the same interface. In this situation, I have few questions:

1. How to prevent routing loop in this situation?

2. What is the administrative distance for ipx rip, eigrp, nslp?

3. How does eigrp and rip convert the metric?

Thank you

Fujin

1 REPLY

Re: ipx over frame relay and route redistribution

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

312
Views
0
Helpful
1
Replies
CreatePlease to create content