Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Is it possible to bind 3 T1 circuits for greater bandwidth?

I have 3 T1 circuits with 3 serial interfaces w/built-in DSU/CSU. Is it possible to bind these 3 circuits to increase the bandwidth?

1 REPLY
Anonymous
N/A

Re: Is it possible to bind 3 T1 circuits for greater bandwidth?

Yes. You can group them together under

a mulitlink interface using MPPP (see the

multilink-group command).

You might try a test to compare this performance

against the performance of just using CEF switching.

Your BW is still fixed at 3 T1's either way,

but CEF may respond faster than MPPP.

171
Views
0
Helpful
1
Replies
CreatePlease to create content