you can't define PUs or LUs in snasw ... the PU or LU name is learned from the VTAM definition when the ACTPU/ACTLU is sent to the snasw dlur. I don't know all the details of PU/LU names with respect to tn3270 (perhaps Jim can comment?) In the sample I pointed you to there were no LUs named, so they would be learned from the VTAM definitions.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...