Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

N7K Port Channel Layer 3 VLAN Question

I have 2 N7K switches and would like to connect them via port channel and put the channel in VLAN 101. I have the following config, does it make sense? Thanks in advance!

interface eth 3/1

switchport

channel-group 101 mode active

interface eth 3/2

switchport

channel-group 101 mode active

interface port-channel 101

switchport

switchport mode access

switchport access vlan 10

spanning-tree network type edge

interface vlan 10

ip address 10.1.1.1/24

Everyone's tags (2)
1 REPLY
Cisco Employee

Re: N7K Port Channel Layer 3 VLAN Question

Could be something like this in the both sides (if the port numbers match):

conf t

feature lacp

feature interface-vlan

interface eth 3/1

switchport

channel-group 101 mode active

interface eth 3/2

switchport

channel-group 101 mode active

interface port-channel 101

switchport

switchport mode access

switchport access vlan 101

spanning-tree port type network

interface vlan 101

ip address 10.1.1.1/24

no shut

end

vlan 101

end

*(This ip address will be available in only one box, you can use a FHRP as well, to increase the level of reachability)

366
Views
0
Helpful
1
Replies
CreatePlease login to create content