The setup is L3 configuration between the VSM and VEM and i am trying to configure NAT between them (i have cisco routers in the middle).
From what I saw, I do not think it can work in a NAT configuration between the VSM to VEM as for the VSM always update the VC of VMWARE what its real ip address (it inform it via application layer rather than on L3 headers, actually in L3 there is a udp encapsulation), then the VC update the VEM about the VSM real IP address and where to open the tunnel.
The VEM will always try to bring up the Tunnel towards the real ip address of the VSM and not towards the Nat ip address.
am i correct ot i need to configure somthing else?
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...