I don't believe so - basically you configure port profiles which are then assigned to VMs via the usual VMWare management tools. The profile follows the server and contains security (and other) settings, but it doesn't use 802.1x to assign these.
There's no mention of 802.1x in the manuals; I'd take that at face value :-).
Please rate helpful posts...
Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...