Nexus 5548UP VFC with multiple physical interfaces
I have a physical host that is evenly quad-homed to a pair of 2248PQ Fex's. Each NIC interface is 10Gb.
Each of my fex's is single homed to a 5548UP in a VPC configuration. I am using FCoE and I have CNA's in my host. My design is below.
On the LAN side, I would like to have a full 40Gb LACP / VPC Port channel. On the FC side, I would like to be able to create a VFC on each side, (or multiple VFC's if that is required), and attach it to both interfaces on each side, so that I have two full FC paths from the host to each SAN fabric, also for a total of 40Gb.
I've seen some Cisco diagrams in some much older forum posts that show that this is not possible, but I've seen nothing recent on this. Does anyone know if it's possible?
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...