Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

nexus1010 connectivity options change

Hi All,nexus1010 has 4 connectivity options. my questions is:

if we initially deploy option 1 for paired 1010 and 1000v switch has been built, are we able to change to other option e.g. option 3 later whithout requesting 1000v rebuild?  Best REGARDS

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

nexus1010 connectivity options change

Hello David,

Yes, the Nexus 1010 'network-uplink type' may be altered after VSBs are installed.  After the configuration change is completed both N1010s must be reloaded at the same time.  The control/packet/data vlans will automatically re-pin to the designated NIC ports.

FYI - In SP1(4) a new Flexible Networking option allows additional topologies.

Matthew

2 REPLIES
Cisco Employee

nexus1010 connectivity options change

Hello David,

Yes, the Nexus 1010 'network-uplink type' may be altered after VSBs are installed.  After the configuration change is completed both N1010s must be reloaded at the same time.  The control/packet/data vlans will automatically re-pin to the designated NIC ports.

FYI - In SP1(4) a new Flexible Networking option allows additional topologies.

Matthew

New Member

nexus1010 connectivity options change

Thank u very much!!!

506
Views
0
Helpful
2
Replies