Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PA-MCX-8TE1 with Full T1.

Is it possible to configure an interface to support a full non channellized T1? If so how?

Thanks

2 REPLIES
Silver

Re: PA-MCX-8TE1 with Full T1.

Have you tried "t1 1 timeslots 1-24?" Please see the following url for details:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/inter_r/irdshoip.htm#1018767

New Member

Re: PA-MCX-8TE1 with Full T1.

Yes, here is my interface/controller config. The T1 interface goes up up but after I config the serial interface goes UP UP then after about 10 seconds the serial goes up down. The T1 never goes down.

version 12.2

service timestamp

service timestamps log uptime

no service password-encryption

!

hostname Router

!

boot bootldr bootflash:c7200-boot-mz.120-17.S

card type t1 1

enable password

!

!

controller T1 1/0

framing esf

service-type data

clock source internal

linecode b8zs

cablelength short 110

channel-group 0 timeslots 1-24

!

!

interface Serial1/0:0

no ip address

!

344
Views
0
Helpful
2
Replies