Power Cables for Cisco 3620 Router and Catalyst 4000 Switch
Does Cisco produce a power cable with an IEC 320 C19 receptacle connector on one end and an IEC 320 C20 plug connector on the other?" I will be connecting the power cord to a PDU that the C20 connector will be plugging in to.
Re: Power Cables for Cisco 3620 Router and Catalyst 4000 Switch
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources online at http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml
If anyone else in the forum has some advice, please reply to this thread.
Introduction This article will help you understand the steps on how to
download the UCS licenses from the Cisco Systems website and then
installing it on the UCS. The redacted (blue lines) just covers up
certain numbers for privacy please do not take them...
Introduction This article will help you understand and educate the
customer on how to clear their "expired licenses"
(license-graceperiod-expired) from their UCS-M. If a customer just
purchased a license and needs a step by step guide on how to download
==================== VIC FNIC driver does not support Virtual Volumes (
second level LUN ID ) An enhancement request has been created to track
this feature - CSCux64473 UPDATE - 12-14-2016 We made some traction on
the enhancement request - The Fix is in t...