problems configuring an E1 PRI, I can't get no more than 15 connections RDIS/modem in 3640
I have a 3640 whith a network module 1FE-2CE1-B/U and one NM-12DM, for analog connections. In this moment the problem is that only 15 connections works ! when I try a 16 connection my modem doesn't connect the signal is ocupied !
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...