Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

problems with an sna-server which wants to connect over cip-router

hi,

my question:

i have a cisco7513 router which is connected to an ibm host over a cip-card.

there is the following configuration on the card:

.

.

lan TokenRing 7

source-bridge 1127 1 1120

adapter 15 4000.1090.0002

name Geos_Tir

and so on.

there is a sna-server which has a connection to the host over this adapter - everything is fine.

now they want to install a new sna-session (lu6.2) from that server to the same adapter.

but it is not possible to configure the new session on the server with the same sap-value (04) as the first session has.

so we tried with a sap of 08 but it does not work - i think my cip-router only "hears" to sap 04.

is there a possibility to configure a second sap value ?

must this new sap-value also match with the config on the ibm-host ??

any idea ???

thanks a lot !

3 REPLIES
Bronze

Re: problems with an sna-server which wants to connect over cip-

You do not configure the SAP value anywhere on the router. It is only specified in the XCA major node so you need to set up a second XCA major node with a different SAP value.

Alternatively you could set up an second adapter with a different mac address as well.

Silver

Re: problems with an sna-server which wants to connect over cip-

Alternatively, you can use a different sap value on the sna-server while you keep the sap value of CIP. This will save you a lot of configuration on CIP and XCA.

New Member

Re: problems with an sna-server which wants to connect over cip-

You will probably need to add a CSNA statement on your physical channel connection, which will match the XCA definition.

175
Views
0
Helpful
3
Replies