Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QLLC to LAN convertion

Hello Forum

we are trying to establish a connection between 2 PUs and the M/F. The two PUs are actually two controllers inside an IBM 400. The IBM 400 is connected to a cisco with an x25 line. The M/F is connected to the ethernet side of the cisco.

So we need to implement a qllc to llc2 media convertion. The problem here is that both PUs use the same local x25 address since they come out of the same x25 line. So, how can we distinguish between these two on the x25 map qllc statement?

If we had only one PU then the configuration would be obvious:

x25 address 111

x25 map qllc 4000.0000.0002 222

qllc dlsw vmac 4000.0000.0002 10 partner 4000.0000.0001 (for example).

But what can we do for the second PU?

Regards, Apostolos.

1 REPLY
Silver

Re: QLLC to LAN convertion

The following document has a configuration example which is similar to the scenario that you are trying to configure. Hope this document will be useful to you.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ibm_c/bcprt2/bcddlsw.htm

127
Views
0
Helpful
1
Replies
CreatePlease to create content