The senerio contains a PIX 515 E firewall,4507R Chassis switch and a CSS 11503. The servers in inside zone of the PIX is load balanced using a vip with default route specified in the CSS is the inside zone interface IP of the PIX
Now I would like to load balance the servers in the DMZ zone of the PIX with a separate vip(from DMZ zone) in the same CSS. Since the default route in CSS is towards the inside zone of the PIX, I am unable to see the load blanced pages from dmz. Is there any solution to load balance the servers of the 2 zones with 2 different vip's using a single css ?
The default behavior is to use the calling device's CSS for the redirected calls. In your case it sounds like you want to use the redirecting device's CSS. I haven't tried this myself but I believe you will need to change the following registry entry on your PGs. You will want to use option 2 (ROUTEADDRESS_SEARCH_SPACE).
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...