Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

sample config for local switching of QLLC to Ethernet?

is it possible to switch a serial attached controller (PU2.0/2.1) over X.25 QLLC to a local attached Mainframe by ethernet?

2 REPLIES
Silver

Re: sample config for local switching of QLLC to Ethernet?

We used Frame Relay across the WAN instead of X.25 and there were no problems with the implemetation. Guess it would work with X.25 too. The following doc gives you the configuration.

http://www.cisco.com/warp/customer/488/48.html

Community Member

Re: sample config for local switching of QLLC to Ethernet?

i know this example config, but i'm searching fo an example where the Mainframe is on the "Ethernet" side where and the PU2.x are at the x25 ones.

198
Views
0
Helpful
2
Replies
CreatePlease to create content