Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Sample Configuration vor PRI (E1) and MICA Modem

Where can I find a Sample Configuration

for a Cisco 3640 with PRI (E1) and a

MICA Modem Card. (Has to work with Dialer Interface)

(I just found a Configuration for PRI (T1) and MICA Modem)

1 REPLY
Anonymous
N/A

Re: Sample Configuration vor PRI (E1) and MICA Modem

The configuratioj for a T1 or E1 is almost the same, except for E1 parameters:

controller E1 0

framing crc4

linecode hdb3

clock source line primary

pri-group timeslots 1-31

controller E1 1

framing crc4

linecode hdb3

clock source line secondary

pri-group timeslots 1-31

interface serial0:15

isdn incoming-voice modem

dialer rotary-group 1

!

interface serial1:15

isdn incoming-voice modem

dialer rotary-group 1

!

interface loopback0

ip address 172.16.254.254 255.255.255.0

!

interface ethernet0

ip address 172.16.1.1 255.255.255.0

!

!The following block of commands configures DDR for all the ISDN PRI interfaces

!configured above. The dialer-group and dialer rotary-group commands tie the

!interface configuration blocks to the DDR configuration.

!

interface dialer1

ip unnumbered loopback0

encapsulation ppp

peer default ip address pool default

ip local pool default 172.16.254.1 172.16.254.60

dialer in-band

dialer-group 1

dialer idle-timeout 3600

ppp multilink

ppp authentication chap pap default

203
Views
0
Helpful
1
Replies
CreatePlease to create content