Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

SDLC multidrop lines

I am trying to connect FEP SDLC link with multiple PUs defined.

The physical controllers are installed at several sites. I am trying to use STUN to encapsulate the SDLC traffic and to distribute to multiple sites.

The actual addresses are being defines in the line are C1, C2, C3 and C4.

I can route relevant addresses to correct IP destination over TCP. But, as per the examples seen on the CCO, there is always FF has been defined as well. So, where should I route this broadcast ?

(I have multiple remote locations and the command will pertmit to router the FF only to a single destination.)

1 REPLY
Silver

Re: SDLC multidrop lines

Nornally, you do not need to route FF because FEP does not send out broadcast .

If you really want to route the broadcast traffic to all sites, please use sdlc virtual-multidrop.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fibm_r1/br1fprt2/br1fstun.htm#1018927

224
Views
0
Helpful
1
Replies
CreatePlease to create content