If the traffic you are sending is SNA then any IOS containing the IBM feature set can be used to configure DLSW to carry the SNA traffic across an arbitrary WAN topology. The 1600 is the lowest end router to contain the IBM feature set.
Cables etc would depend on exactly what interfaces/cables you have in the S/360 but, assuming these are serial interfaces, you typically use the Cisco router to provide clocking so you would use a DCE cable that matched the physical type of DTE cable coming from the S/360, X21 V35 or whatever.
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...