If we knew a bit more about your environment and about your requirements then we might be able to give better answers. Bridging and source route bridging are operations at layer 2 and since IPSec is to transport layer 3 IP packets it is not possible to do native source route bridging and transport it in IPSec. If you were to configure DLSW between the routers which carries the source route bridging between the routers in IP packets then it should be possible to transport the DLSW using IPSec.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...