Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Status 90: Loading Boot Loader

Hi All,

I have problem when I reloaded my Nexus 7000. I tried to enter ROM monitor to init my system by entering Control-C after reloading. I have done this before twice and it went smooth, but when i did it for the third time the boot process stucked on "Status 90: Loading Boot Loader". I have attached the screenshot below.

Is it because my BIOS corrupted?

FYI before I tried to reload the system, iI tried to upgrade my NX-OS from 6.1.1 to 6.1.2 with ISSU but it failed and there was message like this:

un,able to install log files

errno=13

After saw this message, I checked my currently running NX-OS version and it was still 6.1.1 so I assumed that the cuurently running image and kick start didn't got replaced already. After that, I relaoded my system and the problem began. FYI, I have 2 version of image system files and kick start image file (6.1.1 and 6.1.2) in my bootflash and 1 version (6.1.2) of system image and kick start on my slot0.

I try to give all information about my system to ease the troubleshooting. I hope you people can help me in this matter.

thanks in advance.

best regards,

Yedi

Everyone's tags (1)
4 REPLIES

Status 90: Loading Boot Loader

Hi,

I've not come across this before so probably won't be too much help, but have you reviewed the procedures shown in the Troubleshooting Software System Reboots section of the Cisco Nexus 7000 Series NX-OS Troubleshooting Guide on the Cisco DocWiki?

Regards

New Member

Status 90: Loading Boot Loader

Hi Steve,

Yup, I have read that documentation and I arrive in a conclusion that my BIOS is corrupted, but I am not pretty sure about that. The other reason why I suspect my BIOS is corrupted because before reloading the system, I tried to upgrade my system twice (as i mentioned in my post above), and from what I know, upgrading the NX-OS also means upgrading the BIOS. CMIIW

But since I failed upgrading my system, I think my BIOS shouldn't got changed. FYI I got message which notify me that the system failed to extract my new image system and my new kick start image when upgrading process so I assumed that the upgrading system stop at that early stage and didn't touch my BIOS at all. What is your opinion?

One more thing, do you know the function of reset button in Supervisor module? FYI I use SUP-1. Is it for reseting the system to factory default? I can't find any documentation about that reset button.

Thanks for replying.

Best regards,

Yedi

New Member

Hi, I've got the same problem

Hi,

 

I've got the same problem with you.

Are u got the solution for this problem ?

 

best regards,

grivanoj

New Member

Hi Grivanoj, I solved the

Hi Grivanoj,

 

I solved the problem by pulling off the CMOS battery of the supervisor module and wait up to 1 minute before putting it back again in its socket.

 

I hope that will help you.

 

Best regards,

Yedi

812
Views
0
Helpful
4
Replies
CreatePlease login to create content