Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

VS-S720-10G & VSS using supervisor Ports for Server?

Hi all,

We use the SUP VS-S720-10G in our 65k which is configured as VSS.

For the VSS Channel we use one 10Gbit from SUP and one from 10Gbit Line Card.

Now we would like connect a WLC but there are no SFP Ports in the 65k.

Sure, we can buy two Linecards, but just for 2 Ports?

Is it poossible to use the SFP Port of the both SUP like a normal port to configure a channel and connect the WLC?

I'm not really sure if that will work or if I will run in problems.

Thanks in advance

reagards,

Sebastian

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: VS-S720-10G & VSS using supervisor Ports for Server?

Hi Sebastian,

Yes, it's possible to use SFP Portas from ACTIVE chassi and STANDBY chassi.

Take a look: http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps9336/product_data_sheet0900aecd806ed759_ps2797_Products_Data_Sheet.html

Have a nice day !

2 REPLIES
New Member

Re: VS-S720-10G & VSS using supervisor Ports for Server?

Hi Sebastian,

Yes, it's possible to use SFP Portas from ACTIVE chassi and STANDBY chassi.

Take a look: http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps9336/product_data_sheet0900aecd806ed759_ps2797_Products_Data_Sheet.html

Have a nice day !

Re: VS-S720-10G & VSS using supervisor Ports for Server?

Hello,

thanks for your reply, that was the site I already checked but I was not really sure.

Thanks to verify it.

have a nice day too..

- Sebastian

703
Views
0
Helpful
2
Replies