Hello forum,
in a big x25 installation we are doing currently, we observed some errors that most of them apears to have to do with the facilities coded. In most debugs x25 events for example the usual message is cause 3, diag 65 Unknown facility code, facility not allowed, not recognized, facility code not allowed, invalid facility request, etc...
Most of the problems solved by modifying the x25 routing ack local, and on a per interface coding the x25 subscribe facilities etc.
Searching the various references about these commands, sorry to say but I did not find plethora of information. So, It would be very helpful for me, if someone of you could give me some hints on the use of acknowlegments (local or end to end) and the subscription of packet sizes.
For example If I code x25 routing ack local and also code the x25 subscr packet 64 1024 what will happen? Can I code x25 subscr packet 64 1024 and also have the x25 ips and x25 ops coded?
Regards, Apostolos.
