Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Bricked NSS4000

After unsuccessfull firmware upgrade my NSS4000 does not boot. It simply shows yellow power led, then blinking green power led.

I tested the "red blinking" recovery procedure by usb but it doesn't work.

What I can try before RMA it?

Thanks

3 REPLIES
Cisco Employee

Re: Bricked NSS4000

Try removing ALL drives once the NSS is shutdown and then reboot (with drives ejected). If you end up in the same place; blinking Green Power light, perform a factory reset and try again. Factory reset will not erase disk data, just settings. If you are still not successful call Small Business Support Center.

New Member

Re: Bricked NSS4000

I did it. Same behaviour. So last resource is RMA.

Thanks

New Member

Re: Bricked NSS4000

I have the exact same problem! Any solution for it? At the moment the thing is down :(

1241
Views
0
Helpful
3
Replies