In the CDP-F software advanced tab, there is a setting called Maximum Remote Transfer Rate. It says in the help file that if you need to ease the burden on your network you can adjust this field.
Can someone explain what this field is actually adjusting?
If the NSS3000 can link to a 1GB speed network, and if my switch is a 10/100(Mbps) switch and my workstation network card is a 1Gps newtork card than it stands to reason that my fastest rate will be that of the slowest part, that is 100Mbps when switched.
So what does this field actually control?
What kind of error messages will I see if this field is not set properly?
Does this setting affect the through put of the host workstation connecting to the NAS over the network?
Is the level of Product knowledge greater with the folks at 1 866 606-1866?
I find it a little odd that with 3 million hits since January, that Cisco management hasn't equiped you with strong technical resources with intimate knowledge of these products. The longer it takes to get THE answer for an onsite technical problem eventually impacts the next buy decision on a technical solution for the next business opportunity. It's very noble to do this on a volunteer basis. It really shows the dedication of the people supporting this forum. Your better than the old linksys support group.
The CDP-F Maximum remote transfer rate sets a software limit to the transfers that need to take place. This doesn't not take into consideration the HW transfer capability. If a user has 1GB of available transfer bandwidth, but only wants to limit CDP-F traffic to 100MB so that the entire bandwidth is not consumed by one computer making back-ups.
Since backups to the remote server (such as NSS3000) are happening in real time, bandwidth capacity may be an issue depending on the type of traffic on the network. This option in the CDP-F SW just gives admins, one additional place to manage bandwidth.
Article ID:1717 Time Machine Backup on NSS300 Smart Storage Series
Objective This document explains the steps for Time Machine Backup. The
Network Attached Storage (NAS) is used as one of the destinations for
the backup of files. It is a file-level comput...
Article ID:28 Basic and Advanced System Reset on NSS300 Series Smart
Storage Objective The NSS devices have two types of System Resets: Basic
and Advanced. An understanding of both of these resets will allow the
user to recover from unpredictable situatio...
Article ID:40 Expansion of Disk Capacity of RAID 5 on the NSS300 Series
(Except NSS322) Objective RAID stands for Redundant Array of Independent
Disks. RAID 5 combines three or more disks in a way that shields the
data against loss of any one disk. In a R...